We live in a world of solid-state active devices that have made most vacuum tubes obsolete, but a few types remain as they are still indispensable. Part 1 of this article explained the basics of the photomultiplier tube. This part looks into other PMT characteristics. Q: Are there solid-state functional equivalents to the PMT? A: […]
Featured
Vacuum tubes we still (have to) use: The photomultiplier tube, Part 1
Maybe we can’t live with them, but we can’t live without them, at least not yet: the photomultiplier tube and the traveling wave tube are two vacuum electron-tube devices that are still viable and needed in our solid-state world.) It’s widely accepted conventional wisdom that almost “everything” has gone solid state and that vacuum tubes […]
Analog Top Talks in October 2019 on EDABoard.com
Peer-to-peer, engineer-to-engineer questions and answers from the EDABoard.com engineering community around analog ICs and analog design. Click the “Read more” link and follow the entire conversation and maybe add your two cents by logging in to EDAboard.com. Calculate capacitance value from Smith Chart – How do I convert 50.04-j77.16 on a 50 Ohm Smith Chart […]
What are the applications and measurements of S-parameters? Part 2
Part 1 of this FAQ was a basic introduction to the context and concept of S-parameters. Part 2 looks at their measurement, application, and relationship to the time domain. Q: How do you actually measure S-parameters? A: In general, except for approximate measurements, you cannot use a spectrum analyzer alone for this frequency-domain test. Instead, […]
What are the functions and principles of S-parameters? Part 1
As design frequencies now routinely go into the hundreds of MHz and tens of GHz range, conventional voltage and current measurements are not useful. However, scattering (s) parameters can fully characterize the RF component or path performance. For engineers with experience focused from DC to several hundred megahertz, it is usually sufficient to characterize components […]
Fluxgate compasses, Part 2 – Issues and enhancements
Part 1 of this FAQ examined the underlying context of fluxgate compasses and navigation, as well as the basic principles of the fluxgate design. This part looks at additional fluxgate-compass issues and advances in their implementation. The fluxgate compass is fairly simple in principle. However, as with all things related to magnetism in general and […]
Fluxgate Compasses, Part 1 – Context and principles
Despite the availability of GPS and inertial measurement units, the compass in an electronic fluxgate implementation is still a viable and needed navigational tool. The classic magnetic-needle compass is not getting much respect or attention these days. Between the Global Positioning System (GPS) and the Inertial Measurement Unit (IMU) system, the compass – whether it […]
Analog Top Talks in September 2019 on EDABoard.com
Peer-to-peer, engineer-to-engineer questions and answers from the EDABoard.com engineering community around analog ICs and analog design. Click the “Read more” link and follow the entire conversation and maybe add your two cents by logging in to EDAboard.com. 12V DC vending machine motor – I have made some changes with a motor to work with the […]
Printed Circuit Boards, Part 4: Beyond FR-4
Part 4 concludes this FAQ with some fabrication issues and at substrates with performance which is multi-GHz-compatible and goes beyond that available using FR-4 material. Q: What’s the set-up situation for PC board fabrication? A: The production-level fabrication process is optimized for runs of tens, hundreds, and thousands of boards, as there is a set-up […]
Printed Circuit Boards, Part 3: Vias and multilayer boards
Part 1 of this FAQ series looked at the ubiquitous FR-4 PC board as well as other PC board issues, and Part 2 reviewed highlighted some of the board issues and the widely used FR-4 PC board substrate. This third part looks at advanced PB board issues such as vias and multilayer boards. Q: How […]